Express 3/4 Ton Van V8-4.8L VIN V (2003)
Lower Side Moulding / Trim: Service and Repair
Molding Replacement - Rear Quarter (Luxury Y91)
Molding Replacement - Rear Quarter (Luxury Y91)
Tools Required
*
J 25070 Heat Gun
*
J 41409 Body Molding Removal Tool
*
3M 07502 3M Scotch Brite Adhesive and Stripe Removal Disc
Removal Procedure
1. Remove the push-in-retainers from the rear quarter panel molding.
2. Remove the bolt from the bottom of the rear quarter panel.
3. Heat the upper edge of the rear quarter panel molding to 21-32°C (70-90°F).
*
Keep the J 25070 at a distance of 152 mm (6 in) from the surface.
*
Use the J 25070 in a circular motion for 30 seconds.
4. Use a J 41409 in order to strip the upper edge of the rear quarter panel molding from the surface.
5. Remove the rear quarter panel molding from the vehicle.
6. Remove all of the adhesive from the rear door body-panel using 3M 07502 .
7. Clean the rear-door panel-surface. Use naphtha, and allow the surface to air-dry.
Installation Procedure
