chevrolet Workshop Repair Guides

Chevrolet Workshop Service and Repair Manuals

Brakes - Thumping Noise/Feel in Brake Pedal|Page 5143 > < Brakes - ABS Telltale Lamp ON/DTC C0550 Stored
Page 1
background image

Electronic Brake Control Module: Customer Interest
Brakes - Thumping Noise/Feel in Brake Pedal

File In Section: 05 - Brakes 

Bulletin No.: 03-05-25-001

Date: January, 2003

TECHNICAL

Subject:
Thumping Noise/Feel in Brake Pedal 
(Replace Electronic Brake Control Module)

Models:
2003 Chevrolet Express 1500/2500 Series Heavy Duty Cargo Vans
2003 GMC Savana 150012500 Series Heavy Duty Cargo Vans
with GVW of 8600 - 11000 lbs

Condition

Some customers may comment about a thumping noise/feel in the brake pedal after the vehicle comes to a complete stop. This is most likely to occur
after a hard, non-ABS, dry pavement stop.

Important

The above condition may also occur, to a much lesser extent, on all lighter GVW vans. This will NOT occur on Cut-away/Cab-Chassis/Cube/RV
vans.

Correction

Replace the electronic brake control module. Refer to the Electronic Brake Control Module (EBCM) Replacement procedure in the ABS/Traction
Control sub-section of the Service Manual (SI Document ID # 893022). Use the new part numbers listed below.

Parts Information

Parts are expected to be available from GMSPO on January 24, 2003.

Warranty Information

For vehicles repaired under warranty, use the table.

Brakes - Thumping Noise/Feel in Brake Pedal|Page 5143 > < Brakes - ABS Telltale Lamp ON/DTC C0550 Stored