Express 3/4 Ton Van V8-4.8L VIN V (2003)
Parking Brake Warning Switch: Service and Repair
Park Brake Warning Lamp Switch Replacement
Removal Procedure
1. Remove the left trim panel.
2. Remove the electrical connector.
3. Remove the screw from the switch.
4. Remove the indicator switch from the vehicle.
Installation Procedure
1. Connect the indicator switch to the vehicle.
Notice:
Refer to Fastener Notice in Service Precautions.
See: Brakes and Traction Control/Service Precautions/Vehicle Damage Warnings/Fastener Notice
2. Install the screw to the switch.
Tighten the indicator switch retaining screw to 4 Nm (35 inch lbs.).
3. Install the electrical connector
4. Install the left trim panel.
