Express 3/4 Ton Van V8-4.8L VIN V (2003)
Crankshaft Position Sensor: Service and Repair
CKP System Variation Learn Procedure
1. Install a scan tool.
2. Monitor the powertrain control module for DTCs with a scan tool. If other DTCs are set, except DTC P0315, refer to Diagnostic Trouble Code
(DTC) List for the applicable DTC that set.
3. Select the crankshaft position (CKP) variation learn procedure with a scan tool.
4. The scan tool instructs you to perform the following:
-
Accelerate to wide open throttle (WOT).
-
Release the throttle when fuel cut-off occurs.
-
Observe the fuel cut-off for the engine that you are performing the learn procedure on.
-
The engine should not accelerate beyond the calibrated RPM value.
-
Release the throttle immediately if the value is exceeded.
-
Block the drive wheels.
-
Set the parking brake.
-
DO NOT apply the brake pedal.
-
Cycle the ignition from OFF to ON.
-
Apply and hold the brake pedal.
-
Start and idle the engine.
-
Turn the A/C OFF.
-
The vehicle must remain in Park or Neutral.
-
The scan tool monitors certain component signals to determine if all the conditions are met to continue with the procedure. The scan tool only
displays the condition that inhibits the procedure. The scan tool monitors the following components:
-
Crankshaft position (CKP) sensors activity-If there is a CKP sensor condition, refer to the applicable DTC that set.
-
Camshaft position (CMP) sensor activity-If there is a CMP sensor condition, refer to the applicable DTC that set.
-
Engine coolant temperature (ECT)-If the ECT is not warm enough, idle the engine until the engine coolant temperature reaches the correct
temperature.
5. Enable the CKP system variation learn procedure with a scan tool.
6. Accelerate to WOT.
IMPORTANT: While the learn procedure is in progress, release the throttle immediately when the engine starts to decelerate. The engine control is
returned to the operator and the engine responds to throttle position after the learn procedure is complete.
7. Release when the fuel cut-off occurs.
8. The scan tool displays Learn Status: Learned this ignition. If the scan tool indicates that DTC P0315 ran and passed, the CKP variation learn
procedure is complete. If the scan tool indicates DTC P0315 failed or did not run, refer to DTC P0315. If any other DTCs set, refer to Diagnostic
Trouble Code (DTC) List for the applicable DTC that set.
9. Turn OFF the ignition for 30 seconds after the learn procedure is completed successfully.
10. The CKP system variation learn procedure is also required when the following service procedures have been performed, regardless of whether
DTC P0315 is set:
-
An engine replacement
-
A PCM replacement
-
A harmonic balancer replacement
-
A crankshaft replacement
-
Any engine repairs which disturb the CKP sensor relationship
