Express 3/4 Ton Van V8-4.8L VIN V (2003)
Important: This procedure is for 2WD vehicles. If the vehicle is equipped with 4WD, the output speed sensor is located on the transfer case.
2. Disconnect the output speed sensor (2) electrical connector.
3. Remove the output speed sensor bolt.
4. Remove the output speed sensor (2) and the bracket assembly from the case.
5. Inspect the output speed sensor assembly (2) for any evidence of damage.
Installation Procedure
1. Lubricate the output speed sensor seal with automatic transmission fluid.
2. Install the output speed sensor (2) and the bracket assembly.
Notice: Refer to Fastener Notice in Service Precautions.
3. Install the bolt.
^
Tighten the bolt to 11 Nm (96 inch lbs.).
4. Connect the output speed sensor electrical connector.
5. Lower the vehicle.
