Express 3/4 Ton Van V8-4.8L VIN V (2003)
4. Remove the fuel pipes from the bellhousing stud retainer clip.
5. Raise the vehicle. Refer to Vehicle Lifting.
6. Disconnect the fuel feed pipe at the fuel filter.
7. Disconnect the chassis fuel return pipe at the rear fuel return pipe.
8. Remove the fuel pipe retaining clips. Note the location of the retaining clips for installation.
9. Remove the fuel feed and return pipes.
INSTALLATION PROCEDURE
1. Position the fuel feed and return pipes in the vehicle.
2. Install the fuel pipe retaining clips (1).
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten
Tighten the clips to 12 N.m (106 lb in).
3. Connect the chassis fuel return pipe (4) to the rear fuel return pipe.
4. Connect the fuel feed pipe (5) to the fuel filter.
5. Lower the vehicle.
6. Install the fuel feed and return pipes to the engine compartment fuel pipes.
Tighten
Tighten the fuel pipe fittings to 27 N.m (20 lb ft).
7. Install the fuel pipes to the retainer clip.
