Express 3/4 Ton Van V8-4.8L VIN V (2003)
Air Bag(s) Arming and Disarming: Service and Repair
Enabling
Zone 1
1. Remove the key from the ignition.
2. Connect the front end sensor connector to the front end sensor.
3. Install the CPA to the front end sensor connector.
4. Install the SIR fuse into the fuse block.
5. Staying well away from all air bags, turn ON the ignition, with the engine OFF.
5.1.
The AIR BAG indicator will flash 7 times.
5.2.
The AIR BAG indicator will then turn OFF.
6. Perform the Diagnostic System Check - Restraint Systems if the AIR BAG indicator does not operate as described.
Zone 3
1. Remove the key from the ignition.
2. Connect the steering wheel module yellow 4-way connector (2) located left of the steering column near the knee bolster.
3. Install the CPA (1) to the steering wheel module yellow 4-way connector (2).
4. Install the SIR fuse to the fuse block.
5. Staying well away from all air bags, turn ON the ignition, with the engine OFF.
5.1.
The AIR BAG indicator will flash 7 times.
5.2.
The AIR BAG indicator will then turn OFF.
6. Perform the Diagnostic System Check - Restraint Systems if the AIR BAG indicator does not operate as described.
Zone 5
1. Remove the key from the ignition.
