Express 3/4 Ton Van V8-4.8L VIN V (2003)
18.
Install the instrument panel cluster bezel to the instrument panel.
19.
Place the gearshift lever in PARK.
20.
Carefully raise the steering column and install the two bolts. Tighten
Tighten the bolts to 30 N.m (22 lb ft).
21.
Position the passenger side knee bolster trim panel and install the two screws. Tighten Tighten the screws to 3.5 N.m (31 lb in).
22.
Position the driver's knee bolster and install the four nuts. Tighten Tighten the nuts to 10 N.m (88 lb in).
23.
If equipped, reposition the OnStar module and install the bracket screw. Tighten
Tighten the screw to 3 N.m (27 lb in).
24.
Install the two instrument panel bezel nuts (2). Tighten Tighten the nuts to 6 N.m (53 lb in).
25.
Install the driver's side knee bolster trim panel, engage the six retaining clips, and install the two screws. Tighten
Tighten the two screws to 3.5 N.m (31 lb in).
26.
Install the AIR BAG fuse.
27.
Turn the ignition switch to the ON position and verify that the AIR BAG light flashes seven times and goes out.
28.
Install a new label over the existing label on both the driver and passenger sun visors.
