Express 3/4 Ton Van V8-4.8L VIN V (2003)
24.
Install the two outboard bolts attaching the seatback frame to the lower frame.
25.
On seats WITH lumbar features, connect the electrical connectors.
26.
Position the foam pad on the seatback frame.
27.
Position the seat belt retractor to the seat frame and install the upper bolt. Tighten
Tighten the bolt to 53 N~m (39 lb ft).
28.
Install the lower bolt attaching the seat belt retractor to the seat frame. Tighten Tighten the bolt to 53 N.m (39 lb ft).
29.
Attach the seat belt retractor to the seatback tower.
30.
Install the cardboard and attach it to the foam pad. If necessary, apply additional spray adhesive.
31.
Install the seat cover over the top portion of the seatback frame.
32.
Install the head restraint retainers through the openings in the seat cover. The retainers will snap into place when fully seated.
Important
When reinstalling the seatback cover in the next step, verify that the pleats in the seat cover attach correctly to the foam cushion with the hook
and loop fasteners.
33.
Install the seatback cover and attach the J-strip and two push-in retainers at the lower rear of the cover.
34.
Position the seat belt bezel to the retractor tower and snap into place.
35.
On bucket seats, install the armrest to the seat and press inwards until it's retained by the spring clip.
36.
Install the head restraint.
37.
Return the seat assembly to the original position.
