Express 3/4 Ton Van V8-4.8L VIN V (2003)
12.
Remove the screws from the passenger seat pretensioner trim cover and remove the cover.
13.
Remove the pretensioner attaching bolt.
14.
Disconnect the pretensioner electrical connector.
Important
Note the wire routing before removal in the next step in order to route the wiring properly during installation of the new pretensioner.
15.
Route the wiring as necessary and remove the pretensioner from the seat.
16.
Route the connector and wiring of the new pretensioner in the passenger seat.
17.
Position the pretensioner to the seat and install the attaching bolt.
Tighten
Tighten to 40 N.m (30 lb ft).
18.
Position the pretensioner trim cover to the seat and install the attaching screws. Tighten lighten to 2 N~m (18 lb in).
19.
Connect the pretensioner electrical connectors under the passenger seat and install the CPA.
20.
Install the AIR BAG fuse.
21.
Turn the ignition switch to the ON position and verify that the AIR BAG indicator flashes seven times and goes out.
22.
Install the GM Recall Identification Label.
23.
Follow the service manual procedures for deployment of the removed pretensioner assemblies.
RECALL IDENTIFICATION LABEL - For US
Place a Recall Identification Label on each vehicle corrected in accordance with the instructions outlined in this Product Recall Bulletin. Each label
provides a space to include the recall number and the five (5) digit dealer code of the dealer performing the recall service. This information may be
inserted with a typewriter or a ball point pen.
Put the Recall Identification Label on a clean and dry surface of the radiator core support in an area that will be visible to people servicing the vehicle.
When installing the Recall Identification Label, be sure to pull the tab to allow adhesion of the clear protective covering. Additional Recall Identification
Labels can be obtained from Dealer Support Materials.
RECALL IDENTIFICATION LABEL For CANADA
