Express 3/4 Ton Van V8-4.8L VIN V (2003)
Install the new idler arm bracket (1) to the alignment tool (CH-48093-1A) (2) and then to the frame.
With a MIG welder weld the new bracket to the frame.
Apply wax-based anti-corrosion compound to the repair.
Reinstall the ground strap.
Reinstall the idler arm to the bracket and tighten the bolts.
Tighten
Tighten the idler arm to bracket bolts to 150 N.m (111 lb ft).
Reinstall the stabilizer shaft. Refer to Stabilizer Shaft Replacement in SI.
Tighten
Tighten the stabilizer shaft bolts to 25 N.m (18 lb ft).
Reinstall the plastic deflector shield.
Tighten
Tighten the plastic deflector shield bolts to 14 N.m (10 lb-ft).
Lower the vehicle.
Reinstall the negative battery cable.
Check the wheel alignment. Refer to Measuring Wheel Alignment.
Claim Information
