Express 3/4 Ton Van V8-4.8L VIN V (2003)
7. Remove the intermediate shaft bearing bracket retaining nuts.
8. Remove the intermediate shaft lower brace retaining nut.
9. Remove the intermediate shaft bearing from the studs on the cowl and disconnect the intermediate shaft bearing from the upper intermediate shaft.
10. Remove the intermediate shaft bearing.
11. Remove the intermediate shaft seal.
Installation Procedure
1. Install the intermediate shaft seal.
2. Connect the intermediate shaft bearing to the upper intermediate shaft.
3. Connect the intermediate shaft bearing to the studs on the cowl.
Notice: Refer to Fastener Notice in Service Precautions.
4. Install the intermediate shaft bearing lower brace retaining nut.
Tighten the nut to 30 Nm (22 ft. lbs.).
5. Install the intermediate shaft bearing bracket retaining nuts.
Tighten the nuts to 30 Nm (22 ft. lbs.).
