Express 3/4 Ton Van V8-4.8L VIN V (2003)
Notice: Refer to Fastener Notice in Service Precautions.
3. Install the torsion bar support bolts.
-
Tighten the bolts to 95 Nm (70 ft. lbs.).
4. While supporting the adjustment arm, slide the torsion bar rearward until the torsion bar fully engages the adjustment arm.
5. Install the J 36202 to the adjustment arm and the support.
6. Increase the tension on the adjustment arm in order to load the torsion bar.
Important: Install the adjustment bolt the same amount of turns that were required to remove the bolt during removal.
7. Install the adjustment bolt and the adjuster nut.
8. Remove the J 36202 releasing the tension on the torsion bar until the load is taken up by the adjustment bolt.
9. Lower the vehicle.
