Express 3/4 Ton Van V8-4.8L VIN V (2003)
Important:
^
Do not reuse any of the existing retaining rings that were removed from the existing quick connect fittings. All retaining rings being installed must
be new.
^
Ensure the following procedures are performed when installing the new retaining rings onto the fittings.
1. Install a new retaining ring (E-clip) into the quick connect fitting using the following procedure:
2. Hook one of the open ends of the retaining ring in one of the slots in the quick connect fitting.
3. Rotate the retaining ring around the fitting until the retaining ring is positioned with all three ears through the three slots on the fitting.
4. Do not install the new retaining ring onto the fitting by pushing the retaining ring.
