Express 3/4 Ton Van V8-4.8L VIN V (2003)
Important
The illustration above shows the clip being removed in the next step and is for reference purpose only.
16.
Once the threaded section of the lower cable has been pulled out, you should see the small metal clip (1) that attaches the inner cables (2) together.
While holding the white cover back and using a pair of long-nose pliers (3), grasp and pull off the small metal clip through the opening in the cable
connector and discard the clip.
17.
Separate the upper cable from the lower cable and remove the upper cable from the vehicle.
18.
From under the vehicle, push the new cable up through the opening in the floor.
19.
Slide the cover back and pry the lock up the same way as was done on the original cable a few steps earlier.
Important
Do not remove the small metal clip from the NEW cable.
20.
Connect the lower inner metal cable to the upper inner metal cable. When properly engaged, the small metal clip will be locked in the groove in
