Express 3/4 Ton Van V8-4.8L VIN V (2003)
the lower inner metal cable and you should not be able to separate the cables at this time.
DO NOT ADJUST THE CABLE AT THIS TIME.
21.
Move the transmission lever to the PARK position.
22.
Lower the vehicle.
23.
Route the cable, attach the retainer to the floor pan, and install the grommet.
24.
Position the cable and engage the plastic spring clips in the column bracket. Install the retaining clip.
25.
Attach the cable to the ball stud on the column lever.
26.
Verify that the shift lever is still in PARK.
27.
Raise the vehicle.
28.
With both the shift lever and the transmission in PARK, push the threaded section of the lower cable inside of the upper cable as far as it will go
(the blue spring will be fully compressed) and then release it. The cable should spring back and be adjusted at this point.
29.
Press the lock downward to engage and lock the threads of the lower cable in place.
Important
If the white cover does not conceal the lock, the shift cable must be readjusted. If all the gear positions cannot be achieved, the shift cable must
be re-adjusted.
30.
Release the white cover. If the lock is fully seated, the white cover should slide completely over the lock when released.
31.
Lower the vehicle.
32.
Verify proper operation of the shift cable.
33.
Install the driver's knee bolster.
Tighten
Tighten the nuts to 10 Nm (88 lb in).
34.
If equipped, install the OnStar module bracket screws.
Tighten
Tighten the screws to 3 Nm (27 lb in).
35.
Install the driver's side knee bolster trim panel, engage the six retaining clips and install the two screws.
Tighten
Tighten the screws to 3.5 Nm (31 lb in).
36.
Reposition the carpet.
37.
Position the hinge pillar panel to the body and engage the retaining clips.
38.
Install the AIR BAG fuse.
