Express 3/4 Ton Van V8-4.8L VIN V (2003)
9. Remove the front propeller shaft by sliding the front propeller shaft rearward from the transmission.
Installation Procedure
1. Install the front propeller shaft into the transmission.
Align the reference marks made during removal.
Notice: Refer to Fastener Notice in Service Precautions.
Important: The center bearing must be aligned in order to prevent damage to the propeller shaft assembly. When bolting the center bearing in place
on the frame, be sure to keep the center bearing perpendicular (90 degrees) to the propeller shaft.
2. Install the center bearing support bolts (3) to the propeller shaft hanger (1).
Tighten the center bearing bolts to 58 Nm (43 ft. lbs.).
3. Install the rear propeller shaft (3) slip yoke onto the front propeller shaft stub shaft.
Mate the missing tooth in the yoke with the bridged tooth on the splined shaft.
