Express 3/4 Ton Van V8-5.7L VIN R (1998)
![background image](/chevrolet/express_3/4_ton_van/v8-5.7l_vin_r/Page-277015.png)
Push-to-Seat Connector
Push-to-Seat Connector
Push-to-Seat Connector
3. If terminal is to be re-used, re-form locking tank.
4. Make repair.
^
Using a new terminal:
A. Slip cable seal away from terminal (if equipped with seal).
B. Cut wire as close to terminal as possible.
C. Slip a new cable seal onto wire (if equipped with seal).
D. Strip 5 mm (3/16 in) of insulation from wire.
E. Crimp a new terminal to wire.
F. Solder with rosin core solder.
G. Slide cable seal toward terminal (if equipped with seal).
H. Crimp cable seal and insulation (if equipped with seal).
I.
Apply grease to connectors outside the passenger compartment where the connector originally was equipped with grease.
5. To re-use a terminal or lead assembly, refer to Splicing Copper Wire. Be sure to keep cable seal (if equipped) on the terminal side of splice.
Insert lead from the back until it catches. See: Wire Repair Procedures/Typical Electrical Repair Procedures/Splicing Copper Wire Using Splice
Clips See: Wire Repair Procedures/Typical Electrical Repair Procedures/Splicing Copper Wire Using Crimp And Seal Splice Sleeves