Express 3/4 Ton Van V8-5.7L VIN R (1998)
6. Remove the lower shock bolts.
6.1. Pull the shock absorber out from below.
6.2. The lower bushing and the retainer remain on the stem.
INSTALLATION PROCEDURE
1. Install the retainer and the insulators on the shock absorber stem. Fully extend the shaft.
2. Install the shock absorber up through the lower control arm and the spring. Insert the stem end through the hole in the frame bracket.
3. Install the insulators to the stem.
4. Install the retainer to the stem.
5. Install the upper shock retaining nut.
Tighten
Tighten the nut to 16 Nm (12 ft. lbs.), while holding the stem with a wrench.
NOTICE: Always use the correct fastener in the proper location. When you replace a fastener, use ONLY the exact part number for that
application. The manufacturer will call out those fasteners that require a replacement after removal. The manufacturer will also call out the
fasteners that require thread lockers or thread sealant. UNLESS OTHERWISE SPECIFIED, do not use supplemental coatings (paints, greases, or
other corrosion inhibitors) on threaded fasteners or fastener joint interfaces. Generally, such coatings adversely affect the fastener torque and joint
clamping force, and may damage the fastener. When you install fasteners, use the correct tightening sequence and specifications. Following these
instructions can help you avoid damage to parts and systems.
