Express 3/4 Ton Van V8-5.7L VIN R (1998)
3. Apply 11 Nm (98 inch lbs.) torque. If the white line appears in the gauge slot, the pin length is correct.
4. If the white line is not seen in the slot, replace the pin using the following pin identification:
^
One groove, pin length 65.82 - 66.12 mm (2.59 - 2.60 inch)
^
Two grooves, pin length 67.23 - 67.53 mm (2.65 - 2.66 inch)
^
No grooves, pin length 68.64 - 68.94 mm (2.70 - 2.71 inch)
5. Remove the pin and the J33037.
6. Check the 2nd apply piston and the housing dimension.
7. Measure the piston (25) dimension (1)
8. Measure the housing (22) dimension (2)
9. Check the table for the transmission and piston/housing specifications. Refer to 2-4 Servo Pin Selection.
ASSEMBLY PROCEDURE
^
Tools Required
-
J22269-01 Piston Remover