Express 3/4 Ton Van V8-5.7L VIN R (1998)
INSTALLATION PROCEDURE
^
Tools Required
-
J36850 TRANSJEL
1. Install the 8 checkballs (9 Checkballs for some models) into the control valve body.
^
The checkball marked as number 2, is used on RCP, RDP, ZJP and ZLP models only
^
To hold the checkballs in place, use tool J36850
2. Install the PWM screen into the control valve body.
3. Install the manual valve (1) into the control valve body.
4. Install the control valve body gasket.
5. Install the control valve body assembly. Attach the manual valve to the detent lever while installing the control valve body assembly.
6. Install the transmission fluid pressure manual valve position switch.
7. Install the transmission fluid pressure manual valve position switch bolts finger tight.
8. Tighten the bolts in sequence to 11 Nm (97 inch lbs.).
