Express 3/4 Ton Van V8-6.5L DSL Turbo VIN F (1999)
8. Remove the push rods from the engine block.
9. Use a pair of pliers to break off the end of the nylon valve rocker arm retainers from the valve rocker arm shaft.
10. Remove the valve rocker arm retainers with a pair of pliers.
11. Slide the valve rocker arms from the rocker arm shaft.
12. Inspect each of the valve train components.
Installation Procedure
Notice: All valve train components must be reassembled in the exact order and position from which they were removed.
Important: The push rods must be installed in the original direction as disassembly. This is because the push rods have different degrees of hardness
at each end. A paint stripe identifies the upper end of the push rod. If the paint stripe is not visible, mark the push rod on the upper end as the push
rods are removed.
Important: Lubricate the valve rocker arms with clean engine oil before installing.
Notice: Install the valve pushrods with the copper-colored, painted, or marked end up in order to avoid damage or premature wear.
