Express 3/4 Ton Van V8-6.5L DSL Turbo VIN F (1999)
-
J 23523-F Crankshaft Balancer Remover and Installer
Notice: The inertial weight section of the crankshaft balancer is assembled to the hub with a rubber type material. The correct installation procedures
(with the proper tool) must be followed or movement of the inertial weight section of the hub will destroy the tuning of the crankshaft balancer.
1. Install the stud to the crankshaft and thread the stud fully into the tapered hole in the crankshaft.
2. Install the crankshaft balancer (external) over the end of the crankshaft.
3. Install the bearings, washer, and the nut to the crankshaft using the following procedures:
4. Turn the nut to pull the crankshaft balancer (external) into place.
5. Use the J 23523-F to install the crankshaft balancer on the crankshaft.
6. Remove the tool from the crankshaft balancer.
Notice: Refer to Fastener Notice in Service Precautions.
7. Install the crankshaft balancer (external) bolt and washer.
^
Tighten the bolt to 115 Nm (85 ft. lbs.).
