Express 3/4 Ton Van V8-6.5L DSL Turbo VIN F (1999)
5. Remove the engine mount assembly bolts, nuts, and washers.
6. Remove the engine mount through bolt and the nut.
7. Raise the engine only enough to permit removal of the engine mount.
8. Remove the engine mount assembly.
Installation Procedure
1. Install the engine mount bracket to the engine block.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the engine mount assembly bolts, nuts, and washers to the crossmember.
^
Tighten the bolts to 59 Nm (44 ft. lbs.).
^
Tighten the nuts to 45 Nm (33 ft. lbs.).
3. Lower the engine until the engine mount through bolt can be inserted.
