Express 3/4 Ton Van V8-6.5L DSL Turbo VIN F (1999)
Engine Mount: Service and Repair
Engine Mount Replacement (Right)
Removal Procedure
1. Disconnect both the battery negative cable from the batteries.
^
For the front battery, refer to Battery Cable Replacement (Battery Cable Negative) in Starting and Charging.
^
For the auxiliary battery, refer to Battery Cable Replacement (Battery Cable Aux. Negative) in Starting and Charging.
2. Raise the vehicle and support with safety stands.
3. Remove the starter from the engine block (right side only) and secure out of the way.
4. Install a pole jack on the right rear corner of the engine block just above starter.
5. Remove the engine mount through bolt and the nut.
6. Raise the engine only enough to permit removal of the engine mount.
7. Remove the engine mount assembly bolts, nuts, and washers.
