Express 3/4 Ton Van V8-6.5L DSL Turbo VIN F (1999)
8. With the engine OFF, use the J 41711 in order to loosen the right hand injection pump flange nut.
9. With the engine OFF, use the J 41711 in order to loosen the center top injection pump flange nut.
10. Use the J 29872-A in order to slightly rotate the injection pump.
11. Set the actual injection time to 3.5 degrees.
Important: It is normal for actual injection Time value on the scan tool to fluctuate. The average fluctuation of the actual injection Time should
be 3.5 degrees.
12. Continue to repeat until the average fluctuation of the actual injection time is 3.5 degrees.
^
If the actual injection time is above 3.5 degrees, slightly (1 mm equals 2 degrees) rotate the injection pump towards the passenger side of the
vehicle.
^
If the actual Injection time is below 3.5 degrees, slightly (1 mm equals 2 degrees) rotate the injection pump toward the driver side of the
vehicle.
