Express 3500 V8-4.8L (2007)
1. Install the suction line into the vehicle.
Notice: Refer to Fastener Notice.
2. Install the suction line bolt to the compressor.
Tighten the bolt to 35 N.m (26 lb ft).
3. Lower the vehicle.
4. Install the rear suction line nut (2) if equipped with rear air.
Tighten the bolt to 16 N.m (12 lb ft).
5. Install the suction line nut (1) to the accumulator.
Tighten the nut to 16 N.m (12 lb ft).
6. Install the coolant recovery reservoir.
7. Leak test the fittings of the component using the J 39400-A.
