Express 3500 V8-4.8L (2007)
Wheel Fastener: Service and Repair
Rear Suspension
Wheel Stud Replacement
Tools Required
J 43631 Ball Joint Remover
Removal Procedure
1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
2. Remove the tire and wheel.
3. Remove the rotor.
4. Remove the wheel stud from the axle flange using the J 43631 for the 15 series.
5. Remove the axle shaft for vehicles with 9.5 inch ring gear.
6. Remove the rear hub assembly for vehicles with 10.5 inch ring gear.
7. Remove the wheel stud from the axle flange using the J 43631 .
8. Remove the wheel stud from the hub flange using the J 43631 .
Installation Procedure
1. Install the stud into the axle flange for the 15 series.
2. Install the 4 washers and the lug nut to the stud.
3. Tighten the lug nut in order to draw the stud into the flange until the stud fully seats.
4. Remove the lug nut and the washers.
5. Install the axle shaft for the vehicles with 9.5 inch ring gear.
6. Install the rear hub assembly for the vehicles with 10.5 inch ring gear.
7. Install the rotor.
8. Install the tire and wheel.
9. Lower the vehicle.