Express 3500 V8-6.0L (2010)
Restraint Passenger Presence System Replacement - Front (See: Restraint Systems/Air Bag Systems/Seat Occupant Sensor/Service and Repair).
Installation Procedure
1. When replacing a seat cushion pad (2) on a seat equipped with a power adjuster, remove the perforated section (9) on the front of the cushion pad
(2).
2. Position the foam pad (2) to the seat cushion frame (3).
3. Position the seat cushion cover (1) to the foam pad (2).
4. Engage the J channel retainers to secure the seat cushion cover (1) to the seat cushion frame (3).
5. When replacing a seat cushion cover on a seat equipped with a power seat adjuster proceed with the following steps:
1. Locate the opening (1) for the power seat switch within the bracket, through the cover.
2. Using a razor blade make a "X" cut (2) within the opening of the switch bracket.
6. Install the power seat switch. Refer to Power Seat Switch Replacement (See: Power Seat Switch/Service and Repair).
7. Locate the position of the recliner mechanism rod (6) through the cushion cover.
8. Make a small "X" cut just large enough for the recliner rod (6) to go through.
9. Slip the cover over the recliner mechanism rod (6).
