Express 3500 V8-6.6L DSL Turbo (2008)
6. Remove the intermediate shaft seal to the cowl mounting screws.
7. Pull the intermediate shaft seal down and remove the upper intermediate shaft to intermediate shaft bearing retaining bolt.
8. Remove the intermediate shaft bearing bracket retaining nuts.
9. Remove the intermediate shaft lower brace retaining nut.
10. Remove the intermediate shaft bearing from the studs on the cowl and disconnect the intermediate shaft bearing from the upper intermediate shaft.
11. Remove the intermediate shaft bearing.
12. Remove the intermediate shaft seal.
Installation Procedure
1. Install the intermediate shaft seal.
2. Connect the intermediate shaft bearing to the upper intermediate shaft.
3. Connect the intermediate shaft bearing to the studs on the cowl.
