Express 3500 V8-6.6L DSL Turbo (2008)
Front Steering Knuckle: Service and Repair
Steering Knuckle Replacement (RWD)
Tools Required
*
J 24319-B Steering Linkage and Tie Rod Puller
*
J 43631 Ball Joint Remover
*
J 45851 Ball Joint Separator Protector Adapters
Removal Procedure
1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
2. Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation (See: Wheels and Tires/Service and Repair) .
3. Remove the wheel hub and bearing. Refer to Front Wheel Hub, Bearing, and Seal Replacement (RWD) (See: Wheel Hub/Service and Repair
)Front Wheel Hub, Bearing, and Seal Replacement (4WD) (See: Wheel Hub/Service and Repair) .
4. Remove the outer tie rod to steering knuckle retaining nut.
5. Disconnect the outer tie rod from the steering knuckle using J 24319-B .
6. Remove the brake hose bracket retaining bolt from the steering knuckle.