Full Size Chevrolet V8-350 5.7L DSL (1984)
Lifter / Lash Adjuster: Service and Repair
Valve Lifter Service
Fig. 27 Hydraulic roller lifter assembly exploded view
1.
Remove valve lifters, refer to ``Valve Lifters, Replace.''
2.
Using a small screwdriver, remove retainer ring, Fig. 27.
3.
Remove pushrod seat, oil metering valve, plunger, and plunger spring.
4.
Remove check ball retainer from plunger, then remove ball and spring.
5.
Clean parts in a suitable solvent. Do not interchange parts between lifters. If any parts are worn, replace lifter.
6.
Inspect all parts for nicks, burrs or scoring. If any parts are defective, replace lifter.
7.
On roller lifters, inspect roller. It should rotate freely, but without excessive play. Also check for missing or broken needle bearing. If any parts are
defective, replace lifter.
8.
Apply a coating of light engine oil to all lifter surfaces.
9.
Install ball check spring and retainer into plunger. Ensure retainer flange is pressed tight against bottom of recess in plunger.
10.
Install plunger spring over check retainer.
11.
Hold plunger with spring up and insert in lifter body. Hold plunger vertically to prevent cocking spring.
12.
Submerge lifter assembly in clean diesel fuel or kerosene, then install oil metering valve and pushrod seat into lifter and install retaining ring.
