G 10 1/2 Ton Van V8-305 5.0L VIN H 4-bbl (1984)
Figure D - 2nd Seat Installation - Left Seating Position
1.
Left Seating Position - drill an 8 mm (5/16") diameter hole through the floor pan 50 mm (2") inboard of the left wheelhouse and on the fore and aft
center of the flat area of the floor pan located approximately 457 mm (18") rearward of the front edge of the left wheelhouse. Refer to Figure D.
Figure E - 2nd Seat Installation Center or Right Seating Position
OR
Center Seating Position - drill an 8 mm (5/16") diameter hole through the floor pan 546 mm (21-1/2") rearward of the front edge of the left
wheelhouse and on the center of the depressed floor pan rib located 580 mm (22-7/8") inboard of the left wheelhouse. Refer to Figure E.
OR
Right Seating Position - drill an 8 mm (5/16") diameter hole through the floor pan 546 mm (21-1/2") rearward of the front edge of the right
wheelhouse on the center of the depressed floor pan rib located 395 mm (15-1/2") inboard of the right wheelhouse. Refer to Figure E.
