G 10 Van V8-305 5.0L VIN H TBI (1995)
7. Slowly apply brake pedal one time and hold, loosen the bleeder valve to purge air from caliper, then tighten bleeder valve and release pedal.
8. Wait 15 seconds, then repeat sequence, including 15 second wait, until all air is purged from caliper.
9. Repeat bleeding sequence at each wheel until system is bled.
10. Check brake pedal for "sponginess and brake warning lamp for an indication of unbalanced pressure. Repeat bleeding procedure to correct either
of these conditions.
Pressure
Fig. 8 Plastic Reservoir Bleeder Adapter Installation