G 10 Van V8-379 6.2L DSL (1987)
-
Use ONLY the products recommended in this bulletin (or their equivalent).
-
Make sure that any power polishing equipment does not exceed the requirements in the polish manufacturers recommendations or in the chart. The
final process step typically uses an orbital type polisher with speeds of 1,500 to 2,000 R.P.M.
-
DON'T USE WAX OR SILICONE TYPE PRODUCTS TO HIDE SWIRL MARKS (this damage will reappear later and cause customer
dissatisfaction).
-
Specific conditions on paint (environmental damage, rail dust, etc.) can be corrected by referring to previously published service bulletins on those
specific topics.
Contact your local 3M or Meguiar's representative and ask for a demonstration of their products. Their recommended procedures should be followed to
achieve the best results.
We believe these sources, their equipment, and materials to be reliable. There may be additional manufacturers of such materials and equipment. General
Motors does not endorse, indicate any preference for, or assume responsibility for the products or equipment from these items or for any such items
which may be available from other sources.
