G 10 Van V8-379 6.2L DSL (1987)
1. Raise and support vehicle.
2. Using a 0.005 inch feeler gauge or shim, check for gaps between transmission and clutch housing.
3. If a gap or separation is noted, check for interference between top cover and clutch housing. If interference exists, proceed to next step.
4. Loosen, but do not remove, transmission to clutch housing attaching bolts.
5. Remove transmission to cover, then grind excess material from forward side of cover until proper transmission to clutch housing clearance is
obtained. Deburr ground edges.
6. Wash cover with suitable solvent then torque transmission to clutch housing attaching bolts to 100 ft. lbs.
7. Install reworked top cover, using a new gasket.
8. Torque top cover attaching bolts to 20 ft. lbs., then lower vehicle.
