G 1500 1/2 Ton Van V6-4.3L VIN W (1997)
Idle Speed: Testing and Inspection
Idle Speed
When there is a problem with idle air control system or refer to VCM Outputs Diagnosis. See: Powertrain Management/Computers and Control
Systems/Testing and Inspection
-
System too lean (High air/fuel ratio) - Idle speed may be too high or too low. Engine speed may vary up and down, disconnecting IAC does not
help. May set DTC P0171. Refer to DTC P0171 Fuel Trim System Lean Bank 1. See: Powertrain Management/Computers and Control
Systems/Testing and Inspection
-
Scan tool and/or voltmeter will indicate a heated oxygen sensor output less than 300 mV (0.3V). Check for low regulated fuel pressure or
water in fuel. A lean exhaust with a Heated Oxygen Sensor (HO2S) output fixed above 800 mV (0.8V) may be the result of a contaminated
sensor, usually silicone. This may also set a DTC P0172. Refer to DTC P0172 Fuel Trim System Rich Bank 1. See: Powertrain
Management/Computers and Control Systems/Testing and Inspection
-
System too rich (Low air/fuel ratio) - Idle speed too low. Scan counts usually above 80. System obviously rich and may exhibit black exhaust
smoke. Scan tool and/or voltmeter will read a Heated Oxygen Sensor (HO2S) signal fixed above 800 mV (0.8V).
