G 1500 1/2 Ton Van V6-4.3L VIN W (1997)
28-MT Components
INSTALL OR CONNECT
1. New bushing into the drive housing (39) by pressing it in using a suitable tool.
^
Press the bushing in until it is flush with the inside of the housing.
2. New plug (40), if used, to drive housing.
^
Stake the housing material over the plug at three places, equally spaced.
Lubrication
Armature bearings and the driveshaft support bearing are permanently lubricated. Do not add lubricant to these bearings. Using lubricant GM P/N
1960954 or equivalent, lubricate the following areas during assembly. Avoid using excessive grease.
^
Drive end housing bushing in the drive housing.
^
Pivot hole and working surface on the ends of the shift lever.
^
Internal gear, shaft, and spline on the driveshaft.
