G 1500 1/2 Ton Van V6-4.3L VIN W (1997)
Springs And Brushes On The Brush Holder
A. Refer to image for proper installed position of all brushes. Make sure the insulated brushes go into the brush sockets of the brush holder
assembly that mounts on the insulation.
B. To install each brush, grasp the free end of the brush spring with needle nose pliers, twist it to the right to clear the brush socket, and insert the
brush partly into the brush socket.
C. Gradually release the spring so that its end contacts the side (not end) of the brush. This will hold the brushes retracted until after the brush
holder is installed over the armature commutator.
3. Grounded brush screws.
A. Position the terminals of the grounded brush leads behind the terminal tabs on the brush hold.
B. Insert the brush screws through the terminal tabs on the brush holder and thread into the brush lead terminals.
Tighten
^
Grounded brush screws to 1.5 N.m (13 lb in).
Frame, Field, And Brush Holder Group
4. Frame and field assembly to the brush holder assembly.
A. Position the brush holder assembly (with installed brushes) over the terminal end of the frame and field assembly.
B. Attach the terminals of the insulated brush leads to the conductors in the frame and field assembly with insulated brush screws.
Tighten
^
Insulated brush screws to 1.5 N.m (13 lb in).
Unit Assembly
