G 1500 1/2 Ton Van V6-4.3L VIN W (1997)
and Operation/Phasing
1. The Bearing cup into the yoke ear or the propeller shaft.
-
Start the cup seal first into the outer side of the yoke ear.
-
Place the trunnion into position and press the cup inward until there is clearance to insert the retaining ring into the groove.
-
Place the opposite bearing cup into the yoke ear or the propeller shaft.
-
Place the bunion into position, and press the cup inward.
-
Carefully, while pressing the bearing cup inward, ensure proper fit of the universal joint into the opposite bearing cup previously installed.
-
Press the bearing cup inward until there is clearance to insert the retaining ring into the groove.
2. Repeat Steps 1 through 4 as necessary to complete the build of the propeller shaft
3. The propeller shaft.
4. Remove the safety stands and lower vehicle.
