G 1500 1/2 Ton Van V6-4.3L VIN W (1997)
Wiper Blade: Service and Repair
Description
Description
REMOVE OR DISCONNECT
1. Turn ignition switch to 'ACCY" position.
2. Set wiper switch to "PULSE" position. Windshield wiper system should be operating.
3. Turn ignition switch off when wipers are in the innerwipe position and not moving.
4. Wiper blade assembly (5) from wiper arm assembly (4).
A. Push in button (G) of wiper blade assembly clip (H) and remove wiper blade assembly (5) from inside radius of wiper arm assembly (4).
B. Bring wiper arm assembly (4) out through opening in wiper blade assembly (5).
Important
Wiper blade insert must be replaced if removed from wiper blade assembly.
5. Wiper blade insert (6) by pulling out through wiper blade assembly claws (J).
INSTALL OR CONNECT
1. Wiper blade insert (6) in wiper blade assembly (5).
A. Slide wiper blade insert (6) through wiper blade assembly claws (J) until claw (J) is locked into notches (K) in wiper blade insert (6).