G 1500 1/2 Ton Van V8-5.7L VIN R (1997)
Crankshaft: Service and Repair
Reluctor Ring, Replacement
REMOVAL
1. Disconnect the battery negative cable assembly from the battery negative terminal.
2. Remove the coolant reservoir.
3. Remove the air cleaner assembly and intake duct.
4. Remove the engine cooling fan.
5. Remove the water pump.
6. Remove the engine front cover.
7. Remove the crankshaft position sensor reluctor ring.
INSTALLATION
1. Install the crankshaft position sensor reluctor ring.
2. Install the front cover.
3. Install the water pump.
4. Install the engine cooling fan.
5. Install the air cleaner assembly and intake duct.
6. Install the coolant reservoir.
7. Connect the battery negative cable assembly to the battery negative terminal.
-
Tighten the bolt to 15 Nm (11 ft. lbs.).
