G 1500 1/2 Ton Van V8-5.7L VIN R (1997)
4. The relay rod from the idler arm using J 24319-B.
5. The relay rod from the connecting rod using J 24319-B.
Inspect
-
The threads on the tie rod and the tie rod end for damage.
-
The ball stud threads for damage.
-
The ball stud seals for excessive wear.
Clean
-
The threads on the ball stud and the ball stud nut.
Install or Connect
1. The relay rod to the idler arm.
2. The relay rod to the pitman arm ball stud. Make certain the seal is on the stud. Tighten J 29193 or J 29194 to 54 Nm (40 ft. lbs.) to seat the tapers.
Remove the tool.
3. The nuts to the idler arms and the connecting rod.
-
Tighten the nuts to 47 Nm (35 ft. lbs.).
4. The inner tie rod to the relay rod. Refer to "Tie Rod."
5. Lower the vehicle.
