G 20 3/4 Ton Van V8-305 5.0L VIN H 4-bbl (1984)
Figure C - 3rd Seat Installation - Left Seating Position
Only recommended in left seating position.
Left Seating Position
1.
Drill an 8 mm (5/16") diameter hole through the floor pan 76 mm (3") rearward and 10 mm (3/8") inboard of the left wheelhouse. Refer to Figure
C.
2.
To insure proper sealing of the hole, remove any dirt or foreign matter from around the hole on the underside of the floor pan where the sealer is to
be applied.
3.
Place sealer on the hole from the underside of the vehicle and assemble the bolt, anchor bracket, anchor plate, and lock nut to the floor pan as
shown in Figure C. Tighten securely and make certain that the hole is completely sealed. NOTICE: The two (2) 35 mm (1-3/8") O.D. spacer
washers are not needed for this installation.
4.
Use child seat in the third seat - left seating position as directed in the usage instructions. Latching the child seat top strap hook to the anchor
bracket.
NOTICE:
In the event the child seat anchorage assembly is removed, the 8 mm (5/16") diameter hole must be properly resealed.
For All 110 Inch Wheelbase "G" Vans - Front Passenger Seat Installation
A child seat is not recommended for use in the front passenger seat of a 110 inch wheelbase van.
Second Seat Installation - Vehicle Not Equipped With A Third Seat
