G 20 3/4 Ton Van V8-305 5.0L VIN H 4-bbl (1984)
Figure K - Suburban
1.
Drill a 8 mm (5/16") diameter hole through the floor pan 51 mm (2") rearward of the rear edge of the kick-up molding and on the center of the
depressed floor pan rib (see View A - Figure K).
A.
Right Seating Position - 360 mm (14.6") inboard of the right quarter inner panel. Refer to Figure K.
B.
Center Seating Position - 895 mm (35.25") inboard of the right quarter inner panel. Refer to Figure K.
2.
To insure proper sealing of the hole, remove any dirt or foreign matter from around the hole on the underside of the floor pan where the sealer is to
be applied.
3.
Place sealer on the hole from the underside of the vehicle and assemble the bolt, anchor bracket, anchor plate, and lock nut to the floor pan as
shown in View
A.
Tighten securely and make certain that the hole is completely sealed. Do not make the anchor installtion without properly sealing the
assembly.
4.
Use the child seat only in the front seat - seating position for which the anchor bracket has been installed. Use the child seat as directed in your
child seat manufacturer's usage instructions, latching the child seat top strap hook to the anchor bracket.
NOTICE:
In the event the child seat anchorage assembly is removed, the 8 mm (5/16") diameter hole must be properly resealed.
Suburban
SECOND SEAT INSTALLATION - VEHICLES NOT EQUIPPED WITH A THIRD SEAT
1.
Drill a 8 mm (5/16") diameter hole through the floor pan 650 mm (25-1/2") rearward of the rear edge of the kick-up molding and:
