G 20 3/4 Ton Van V8-305 5.0L VIN H 4-bbl (1984)
"C-K" Pickup
Place the child seat in the front seating position (rear seating position on four (4) door models) in which the child seat is to be used and secure the vehicle
lap belt over the armrests of the child seat. This will correctly position the child seat for the anchor bracket installation.
Figure I - C-K Pickup
Select a suitable anchor bracket mounting location on the cab back panel (see Figure I). The location must be:
A.
Located near the rear window reinforcement. If a lower mounting position is desired, the angle between the child seat top strap and horizontal
should not exceed 45~.
B.
As close to the centerline of the child seat as possible, but in no case more than 50 mm (2 inches) outboard or 150 mm (6 inches) inboard of the
child seat centerline.
C.
In a position clear of fuel tank, fuel lines, brake lines, exhaust systems, etc.
Drill a 8 mm (5/16") diameter hole through the cab back panel of the selected location.
Assemble and securely tighten bolt, anchor bracket, anchor plate, 2-1/2" O.D. washer and lock nut to the cab back panel using a suitable sealer around
the hole. Make certain that the hole is properly sealed to prevent exhaust fumes from entering the cab.
Use the child seat only in the seating position for which the anchor bracket has been installed, latching the child seat top strap hook to the anchor bracket
as shown.
CAUTION: In the event that the child seat anchorage assembly is removed, the 8 mm (5/16") diameter hole must be properly resealed to prevent toxic
exhaust fumes from entering the cab.
Blazer
