G 20 Van V6-262 4.3L VIN Z (1993)
6.
Cut template out on solid line as indicated (Figure 1).
7.
Bend template along radius of the door.
Note:
Right Door/Left Door orientation.
8.
Tape template into position. "V" notch of template should be centered around weatherstrip fastener hole.
9.
Using a center punch, mark all four corners of dotted line of template.
10.
Inscribe lines to connect punch marks.
11.
Remove template and cut out area of door using a fiber cutting wheel.
12.
Position, clamp and weld reinforcement plate (P/N 15988857) into place (Figure 2, Item 5).
13.
Grind weld residue and prepare surface for repaint.
14.
Install weatherstrip on door.
15.
Connect rear window defroster wiring harness (if equipped).
16.
Install door trim panel (if equipped).
17.
Install door check strap bracket (P/N 15963207) (Figure 2, Item 1) using four bolts (P/N 180018) (Figure 2, Item 3).
18.
Install door check "L" pin (Figure 2, Item 2).
