G 20 Van V6-262 4.3L VIN Z (1993)
Clutch Plate And Hub Assembly Removal
3. Thread the Clutch Plate and Hub Assembly Remover J 33013-B into the hub. Hold the body of the remover with a wrench and turn the center
screw into the remover body to remove the clutch plate and hub assembly.
4. Remove the shaft key and retain for reassembly.
Install or Connect
Shaft Key, Clutch Plate/Hub Assembly
1. Install the shaft key into the hub key groove. Allow the key to project approximately 3.2 mm (1/8") out of the keyway. The shaft key is curved
slightly to provide an interference fit in the hub key groove.
2. Be sure the frictional surface of the clutch plate and the clutch rotor are clean before installing the clutch plate and hub assembly.
3. Align the shaft key with the shaft keyway and place the clutch plate and the hub assembly onto the compressor shaft.
NOTICE: Do not drive or pound on the clutch hub or shaft. Internal damage to compressor may result.
