G 20 Van V6-262 4.3L VIN Z (1993)
7. Rotate the pulley rim and rotor to insure that pulley rim is rotating "in-line". If pulley rim is distorted (does not rotate in-line), adjust or replace
pulley rim.
8. Tighten pulley rim mounting screws to 11 N.m (100 in.lbs.) torque and lock screw heads in place by bending screw head washer similar to
original crimp.
9. Reinstall Clutch Plate and Hub assembly as described in "Compressor Clutch Plate and Hub" Replacement procedures.
6 Pole Clutch
Remove or Disconnect
1. Remove the clutch plate and hub assembly as described previously.
Removing Rotor & Bearing Assembly Retainer Ring
2. Remove rotor and bearing assembly retaining ring. using Snap Ring Pliers J 6083.
Removing Clutch Rotor Assembly - Poly-Groove Drive
