G 20 Van V6-262 4.3L VIN Z (1993)
^
The motor pinion gear teeth must mesh properly with the sector gear teeth before installing the motor to regulator screws.
2. Regulator motor to regulator screws. Remove the sheet metal screw from the back plate and sector gear.
3. Window regulator to the door.
^
Collapse the regulator, and insert it through the access hole in the door.
^
Unfold the regulator; and engage the forward roller to the sash channel at the sash channel notch.
^
Slide the regulator rearward to engage the rear roller to the sash channel. Also engage the lower roller to the regulator rail.
^
Slide the regulator into its proper position.
Tighten
^
Regulator to door bolts to 9.5 N.m (84 in. lbs.).
4. Wiring harness to the regulator.
5. Regulator to door panel bolts (244) and nuts (245).
6. Remote control to door trim panel bolts.
7. Door trim panel.
8. Negative (-) battery cable.
^
Remove the tape from the window.
